Most vinyl lattice panels come pre-made in 4 x 8 feet rectangular panels. If your ground pitch is 4 inches, the next post should be 4 inches shallower into the ground and the next panel should be secured at a height 4 inches less taller than the previous panel. The difference between them is your ground pitch. Take the sticks out and measure from the bottom of the stick to the string. Then tie a string around both sticks close to the ground.
If your application does support the use of anchors, you can consider core drilled holes. Finally, each base plate is secured to the concrete using concrete anchor bolts. Holes are drilled into the concrete with a hammer drill. In order to figure out if the land is on an incline, ground in two sticks in front of two adjacent posts. Metal base plates are welded to the bottom of each post. A 90 degree post should be aligned with the direction of the string. Tie a weight on a string and let it drop alongside a post. Check to see if there is an incline so that you can order taller posts for hilly area fence installation. Use a string pulled taut against the fences to make sure that all posts are in alignment. Measure each time a new post is put in, using the previous post to check measurements against. Instead of finding out towards the end of installation that a hole is too deep, too shallow, or a post is out of line, always double check your work as you go. The more watery the cement mixture, the more harder it will be to keep the fence level while it is curing. For best results, pre-mix the cement in a wheelbarrow instead of pouring in powder and water separately into the hole in the ground. Use as little water as possible in mixing cement. This method is more slow-going at first, but will require less repair time later.
MOUNTING VINYL LATTICE PANELS TO ALUMINUM POSTS INSTALL
Instead, install the first post by digging the hole and cementing the post, and use the upright post to begin measuring for the location of the second post. Contrary to popular fence installation manuals, digging holes, cementing the posts, then finding out that the spacing is off when trying to install the framework is a costly no-no.
0 kommentar(er)
